Even imagining our existence without a water heater is challenging.
Who wouldn’t desire a hot water shower after a long day at the office?
The majority of individuals install water heaters but do not maintain them, causing them to malfunction and shorten their lives.
Follow these simple guidelines to keep your water heater in good working order for a longer period of time.
Test the TPR valve to begin the maintenance procedure.
When the pressure in the tank surpasses the set point, the TPR valve opens. Place a bucket under the pipe that connects to the TPR valve to test the valve.
It can be found on the top or side of the water tank. Turn off the cold-water and power valves before moving on to the next procedure.
Lift the tap to let some water out. After a minute, release the valve. Examine the valve; if the water does not cease flowing, the valve is faulty.
After draining the tank and unscrewing the old valve, replace it.
Checking the anode rod is another vital part of the water heater maintenance routine.
By connecting a hose to the water tank’s drain cock, you can release a few liters.
Fit one 1/16-inch socket on the anode rod’s hexagonal head, which can be found on top of the heater or under the top plate of the heater, to unscrew it.
Measure the thickness of the anode rod; if it is less than half an inch thick or has calcium extracts on it, it needs to be replaced.
Purchase a new anode rod for your water heater and wrap the rod’s thread with Teflon tape before installing it. Make sure it’s tightly screwed back into place.
Sediment may be present in the tanks of a water heater, reducing the heater's performance.
Drain the water from the tank and stir the sediment that has accumulated at the bottom. Do it while opening the cold-water faucet for a few seconds. Rep the procedures until the hose produces clean, clear water.
Close the drain cock once you see clean water coming out of the tank’s hose. Before you begin the process of washing away the sediment, make sure the power is turned off.
Condensation, which can deposit rust on the pipes, is avoided by insulating the hot and cold water pipes of the water heater.
Purchase pipe insulation that is no more than 3/8 inch thick. Make sure it’s the same diameter as your heater’s pipes.
Get an insulating covering for the heater’s body. If you have an oil or gas water heater, do not cover the top.